Sunday, 5 September 2010

Why Automatic Cars Require Torque Converters

A torque converter is a mechanical device, primarily used in cars that power by rotating a vehicle's engine to power generated transfers. It is part of a family of mechanisms such as fluid couplings "to use the hydraulic fluid to mechanical power transmission known. A converter is installed in automatic transmissions, making the job of a clutch in a manual transmission would enable the power-created by the engine to be distributed to the wheels.

There are three main torque converter parts: a pump, a turbine and a stator. The high performance of a converter depends greatly on the quality of these parts. The pump is connected directly to the motor, and rotates with the same speed as the engine. Torque repair is needed immediately if the pump goes out. The turbine then rotates at almost the same speed as the engine, but in the opposite direction. The spinning of the turbine caused to rotate the torque converter automatic and drives the wheels. The hydraulic fluid leaves the turbine in the middle, moving in the opposite direction, as it was forced through the pump.

A converter has three operating phases (a) stable, (2) acceleration and (3) coupling. While the accommodation and acceleration phases, in which torque multiplication occurs, the stator remains stationary by the action of one-way clutch. However, since the torque converter approaches the coupling phase, the energy and the volume of liquid back from the turbine is reduced gradually, thus the pressure on the stator to reduce the same. Once in the coupling phase, the liquid again reverse direction and then rotates in the direction of the pump and turbine, an effect that the experiment is to rotate front and the stator. At this point, the stator converter clutch and release the pump, turbine and stator is all (more or less) again as a unit.

Besides the very important task of keep your vehicle to a complete stop without stalling the engine coming, the torque converter actually gives your car more torque when you accelerate from a stop. Modern converter can multiply the torque of the engine by two fifty-eight time. This effect occurs only when the engine turns much faster than the transfer.

At higher speeds, the transmission catches up to the engine, eventually moving at almost the same speed. Ideally, if the transfer at exactly the same speed as the motor would move, because the difference in speed wastes power. This is part of the reason why cars with automatic transmissions get worse gas mileage than cars with high performance torque converter and transmission.

To counteract this, install a few cars a torque converter with a lockup clutch. If the two sides to speed up the converter, this clutch locks them together, so that the slippage and improving efficiency.

AmeriCorps torque is a torque converter shop, the all-in-one torque-repair specialist, torque Rebuild provider, reprocessing and torque socket. Install a high-performance converter to your car now and secure hundreds of dollars for repairs. They serve the areas of Tampa, Brandon, St. Petersburg, Clearwater, Lakeland, Hillsborough, Pinellas, Pasco and Polk.


Post a Comment